| Item | Z5000-BF inverter |
| Control Mode | Sensorless flux vector control(SFVC) Voltage/Frequency (V/F) Control |
| Maximum frequency | Vector control:0-320Hz V/F control:0-3200Hz |
| Carrier frequency | 1kHz~16kHz The carrier frequency is automatically adjusted based on the load features. |
| Input frequency resolution | Digital setting:0.01Hz Analog setting: Maximum frequency 0.025% |
| Start torque | G: Type:0.5Hz/150%(SVC) P: Type:0.5Hz/100% |
| Speed range | 1:100(SVC) |
| Speed stability accuracy | ±0.5%(SVC) |
| Overload capacity | G Type:60s for 150% of the rated current, 3s for 180% of the rated current. P Type:60s for 120% of the rated current, 3s for 150% of the rated current. |
| Torque boost | Auto-boost ; Customized boost:0.1%~30.0% |
| VF curve | Line V/F curve；Multi-point V/F curve；N-power V/F curve |
| VF separation | 2 types: complete separation；half separation |
| Ramp Mode | Straight-line ramp；S-curve ramp；Four groups of acceleration/deceleration time:0~6500.0s |
| Auto voltage regulation(AVR) | It can keep constant output voltage automatically when the mains voltage changes |
| Rapid current limit | It helps to avoid frequent over current faults of the AC drive. |
| Torque limit and control | It can keep constant output voltage automatically when the mains voltage changes |
| Onboard PID | It realizes process-controlled closed loop control system easily |
| JOG control | JOG frequency range: 0.00–50.00 Hz JOG acceleration/deceleration time: 0.0–6500.0s |
| DC braking | DC braking frequency:0.00Hz to maximum frequency Braking time:0.0-100.0s Braking action current value:0.0%-100.0% |
| Instantaneous blackout doesn’t stop | The load feedback energy compensates the voltage reduction so that the AC drive can continue to run for a short time. |
| Timing control | Timing range:0.0Min~6500.0Min |
| Communication | RS485 |
| Run command channel | Given by the panel,control terminals,serial communication port,can be switched by many ways |
| Frequency source | 10 kinds of frequency source, given by digital analog voltage, analog current, pulse, serial port. It can be switched by many ways |
| Auxiliary frequency source | 10 kinds of frequency source, can easily realize micro adjustment, frequency Synthesizer |
| Input terminals | 6 digital input terminals, one of which supports up to100 kHz high-speed pulse input (optional). 2 analog input terminal, one of which only supports0-10 V voltage input and the other supports 0-10V voltage input or 4-20 mA current input. |
| Output terminals | 1 digital output terminal 1 relay output terminal 1 analog output terminal: that supports 0-20 mA current output or 0-10v voltage output |
| Multiple protection modes | Motor short-circuit detection at power-on, output phase loss protection, over-current protection, over-voltage protection, under voltage protection, overheat protection and overload protection. |
